- Swing,car alarm installation manual performance teck,polaris sportsman service manual download,mentors fingerprint leave mark difference,hp officejet 5110 service manual,the bird is on the wing aerodynamics and the progress of the american airplane,manuel decole du dimanche volume 2.
- Viper is the most recognized name in vehicle security and auto remote start systems, and an industry leader in cloud connected car technology. Viper products.
. CA-310 Installation Instructions PROFESSIONAL INSTALLATION STRONGLY RECOMMENDED Installation Precautions: Roll down window to avoid locking keys in vehicle during installation Avoid mounting components or routing wires near hot surfaces Avoid mounting components or routing wires near moving parts Tape or loom wires under hood for protection and appearance Use grommets when routing wires through metal surfaces. INSTALLATION OF THE MAJOR COMPONENTS Control Module: Select a mounting location inside the passenger compartment (behind the dash), and secure using the two screws provided. The control module can also be secured in place using cable ties. Be certain that the chosen location will not interfere with the proper operation of the vehicle.
WIRING THE SYSTEM Red: +12 VDC CONSTANT BATTERY SOURCE Connect this wire to a +12 Volt constant source found at the vehicles ignition switch. This wire provides power for the control module. Orange: 300 mA Ground Output When Armed -N.C. Starter Disable This wire is provided to control the starter disable relay. Grey: (-) Hood/Trunk Trigger This is an instant on ground trigger wire. It must be connected to the previously installed hood and/or trunk pin switches.
Such installation plans with a Tyco Integrated Security service technician prior to. Your FOCUS® 200 PLUS security system can accommodate an Auto On/Off feature. Range of 90° to 105°F, the detection performance can decrease.
Spy Car Alarm Installation Manual
Green: Negative Door Trigger Input If the vehicle’s courtesy light switches have a (-) ground output when the door is opened (GM and most Imports), you must connect the Green wire to the negative output from one of the door switches. Black/White: Illuminated Entry Output 200 mA (-) This wire provides a 30 second ground output whenever the system is disarmed using the OEM transmitter, and pulses ground when the alarm is triggered.
Car Alarm Installation Manual Performance Tecknet
It is used to providethe optional entry lighting feature, and will flash the vehicle's interior light when the system is triggered. COMPLETING THE INSTALLATION Adjusting the Shock Sensor: Gently turn the adjustment knob counterclockwise to turn down the sensitivity and turn clockwise to turn up sensitivity. Close the hood and trunk lids, and arm the alarm. Wait 6 seconds for the accessories trigger zone to stabilize, then test the sensitivity adjust as needed CAUTION: Never perform this test on the vehicle’s glass, as you may break the window.
1 - 8 128-6832 7 of 16.